EP9224-0037 | 4-channel power distribution box ENP to EtherCAT P
1 | Tx+
2 | Rx+
3 | Rx-
4 | Tx-
5 | GNDP
6 | PE
7 | UP
8 | GNDS
9 | US
1 | Tx+/GNDS
2 | Rx+/GNDP
3 | Rx-/UP
4 | Tx-/US
Power/EtherCAT OUT
Power/EtherCAT IN
extended temperature range

EP9224-0037 | 4-channel power distribution box ENP to EtherCAT P

The EP9224-0037 enables power distribution from a B17-ENP input to four EtherCAT P ports with B17-ENP forwarding. In each EtherCAT P junction, the current consumption for the control voltage US and the peripheral voltage UP is monitored, limited and if necessary switched off.

The input voltage and current values of all outputs can be evaluated via the process data. A 5-pin B17-ENP connector is used for communication with the box and for power supply of power to and with up to 14 A (per US/UP). Several modules can be configured in a cascade arrangement through power forwarding. In case of a short circuit on one of the four outputs or eight voltages (4 x US/4 x UP), this voltage is switched off. The supply for the other junctions remains active. The switch-off or voltage regulation is carried out in such a way that the input voltage does not drop below a critical value. A continuous log of the relevant data can be retrieved in the event of an error. During start-up consumers with large capacities can be added without problem.

The diagnostic messages of the individual channels can be read by the master via the EtherCAT interface. Independent switching of individual consumer branches is also possible via the EtherCAT master.

Technical data EP9224-0037
Task within EtherCAT system coupling to the EtherCAT network, EtherCAT P junction, feed in and monitoring of US and UP
Number of channels IN: 1 x ENP, OUT: 1 x ENP, 4 x EtherCAT P
Current rating per port max. 3 A per US and UP (M8 EtherCAT-P-coded)
Protocol EtherCAT
Data logging recording of relevant data in case of failure
Special features input voltages/currents, output currents via process data
Operating/storage temperature -25…+60 °C/-40…+85 °C
Vibration/shock resistance conforms to EN 60068-2-6/EN 60068-2-27
EMC immunity/emission conforms to EN 61000-6-2/EN 61000-6-4
Approvals CE, UL in preparation
ZK700x-010x-0xxx Cables for EtherCAT P: Ultra-fast Communication and Power in One Cable
ZK7208-xxxx-Axxx ENP connector family in size B17, 5-pin
5 G 1.5 mm² + (1 x 4 x AWG22)
Product announcement
estimated market release 1st quarter 2018