Digital output
EQ2809-0022
 
EQ2809-0022 | 16-channel digital output 24 V DC, I<span class="EFF_MAX_subscript">MAX</span> = 0.5 A (∑ 4 A)
EQ2809-0022
Connector
assignment
I/O
connection
M12 I/O
connection socket
Signal status display
Power supply
status display:
Box supply (US)
Auxiliary voltage (UP)
1 | + 24 V DC Us
2 | Output B
3 | GND
4 | Output A
5 | n.c.
1 | Tx+
2 | Rx+
3 | Rx-
4 | Tx-
1 | + 24 V DC Us
2 | + 24 V DC UP
3 | GNDs
4 | GNDP
3-wire  2-wire
Power supply feed
Power supply down-
stream connection
EtherCAT
signal input
EtherCAT
signal output
extended temperature range

EQ2809-0022 | 16-channel digital output 24 V DC, IMAX = 0.5 A (∑ 4 A)

The EQ2809 EtherCAT Box with digital outputs connects the binary control signals from the controller on to the actuators at the process level. The 16 outputs handle load currents of up to 0.5 A each, although the total current is limited to 4 A. This makes these modules particularly suitable for applications in which not all of the outputs are active at the same time, or in which not all of the actuators draw 0.5 A current.

The signal state is indicated by means of light emitting diodes. The signals are connected via M12 screw type connectors. The outputs are short-circuit-proof and protected against inverse connection.

The modules of the EQxxxx series are made of stainless steel and feature the “Hygienic Design” completely. Therefore they are ideal for applications in the food, chemical or pharmaceutical industries, which require protection class IP 69K.

Technical data EQ2809-0022
Number of outputs 16
Rated load voltage 24 V DC (-15 %/+20 %)
Output connections M12, screw type
Protocol EtherCAT
Bus interface 2 x M8 socket, shielded, screw type
Load type ohmic, inductive, lamp load
Nominal output voltage 24 V DC (-15 %/+20 %)
Max. output current 0.5 A per channel, individually short-circuit-proof, total current max. 4 A
Short circuit current typ. 1.5 A
Distributed clocks
Auxiliary power current typ. 20 mA + load
Current consumption from US (without sensor current) 130 mA
Power supply connection feed: 1 x M8 male socket, 4-pin; downstream connection: 1 x M8 female socket, 4-pin
Bit width in the process image 16 outputs
Electrical isolation 500 V
Special features V2A stainless steel, Hygienic Design
Operating/storage temperature -25…+60 °C/-40…+85 °C
Vibration/shock resistance conforms to EN 60068-2-6/EN 60068-2-27
EMC immunity/emission conforms to EN 61000-6-2/EN 61000-6-4
Protect. class/installation pos. IP 69K (according to EN 60529)/variable
Approvals CE, UL
Accessories  
ZK1090-3xxx-xxxx Cables for EtherCAT signal in- and -output
ZK2000-6xxx-xxxx Cables for M12 I/O connection sockets
ZK2020-3xxx-xxxx Cables for M8 power supply
Stainless steel products  
For further information on the stainless steel control solution please see here.