Digital output
IE2512
 
IE2512 | 2-channel pulse width output 24 V DC
IE2512
Connector
assignment
I/O
connection
M12 I/O
connection sockets
(grey = not connected)
Signal status
up/down
Labelling areas
Power supply
status display:
Box supply (US)
Auxiliary voltage (UP)
Signal status
PWM output
1 | + 24 V DC Us
2 | Up/Down
3 | GND
4 | Output
5 | n.c.
1 | + 24 V DC Us
2 | + 24 V DC UP
3 | GND
4 | GND
3-wire  2-wire
Power supply feed
Power supply down-
stream connection
IP-Link interface

IE2512 | 2-channel pulse width output 24 V DC

The outputs of the IE2512 module provide a pulse width modulated version of a binary signal. The keying ratio is prescribed by a 16 bit value from the automation unit. The output is protected against overload and short circuit. In addition to the PWM operating mode, the outputs can also be frequency modulated or used to control stepper motors with specified pulses and direction. The module contains two channels that indicate their state by means of light emitting diodes. The LEDs are driven in time with the outputs and show the keying ratio by their brightness.

Technical data IE2512
Number of outputs 2
Output connections M12, screw type
Load type ohmic, inductive
Nominal output voltage 24 V DC (-15 %/+20 %)
Max. output current 2.5 A per channel, individually short-circuit-proof
Current consumption from US (without sensor current) 25 mA
Up/down channel 24 V DC, 0.5 A, short-circuit-proof
Base frequency 8 Hz…40 kHz, default: 250 Hz
Duty factor 0…100 % (TON > 750 ns, TOFF > 500 ns)
Resolution max. 10 bit
Freewheeling diode (output) yes
Power supply connection feed: 1 x M8 male socket, 4-pin; downstream connection: 1 x M8 female socket, 4-pin
Bit width in the process image 48 inputs/outputs: 2 x 16 bit data, 2 x 8 bit control/status
Electrical isolation channels/control voltage: no, between the channels: no, control voltage/fieldbus: yes, via IP-Link
Operating/storage temperature 0…+55 °C/-25…+85 °C
Vibration/shock resistance conforms to EN 60068-2-6/EN 60068-2-27
EMC immunity/emission conforms to EN 61000-6-2/EN 61000-6-4
Protect. class/installation pos. IP 65/66/67 (conforms to EN 60529)/variable
Approvals CE, UL