Shielding connection system
 

Shielding connection system

The shielding connection system enables the shielding to be located very close to the terminals of the shielded line, so that interference is reduced to a minimum. A shield busbar for attachment to a mounting rail or a bracket for separate mounting in the control cabinet are available.

Shield busbar with mounting rail holder

Ordering information necessary components for mounting on a mounting rail Pict.
ZB8500 clamp strap for shield connection with knurled screw, width 11 mm, shield diameter max. 8 mm, packing unit = 10 pieces
A
ZB8501 clamp strap for shield connection with knurled screw, width 19 mm, shield diameter 7…16 mm, packing unit = 10 pieces
B
ZB8510 shield busbar 10 x 3 mm, 1000 mm galvanised Cu, packing unit = 1 piece
C
ZB8520 mounting rail holder for shield busbar (10 x 3 mm), packing unit = 2 pieces
D
ZB8530 U-clamp terminal up to 4 mm² for PE connection to the rail (10 x 3 mm), packing unit = 20 pieces  
A
ZB8500
B
ZB8501
C
ZB8510
D
ZB8520
 

Shield busbar clamps

Ordering information necessary components for separate mounting in a control cabinet Pict.
ZB8500 clamp strap for shield connection with knurled screw, width 11 mm, shield diameter max. 8 mm, packing unit = 10 pieces
A
ZB8501 clamp strap for shield connection with knurled screw, width 19 mm, shield diameter 7…16 mm, packing unit = 10 pieces
B
ZB8511 shield busbar clamp 10 x 3 mm for 5 Bus Terminals/EtherCAT Terminals 12 mm, packing unit = 10 pieces
C
ZB8530 U-clamp terminal up to 4 mm² for PE connection to the rail (10 x 3 mm), packing unit = 20 pieces  
A
ZB8500
B
ZB8501
C
ZB8511